Ok, need some help baggin my Toyota Van

Ok, it didnt sell so I am just going to go through with my plans. I wanna bag my van but I cannot weld cause my hands wont let me(long story). Anyways, my van the front suspension as a 2WD Toyota truck, and the rear is coil spring set up with a 4link setup. So the rears should be really easy to do, but I will need some help with the front. If anybody in Orlando area or close to can help me that would be great. I can be reached at 407-408-4429 but sometimes hard to get ahold of so just post up here.

Again if someone can help me out, of course I can shell out a few bucks. Also, I am looking into doing this within the next few months so all info will be appreciated.

Danny

It'll be bad ass when its done.

The older Toyota vans are cool. When you're tuning the motor with the driver seat out, you can sit right on top of the intake and drive it around while adjusting the timing!