Page 2 of 2
General Discussion \ Newbie with a recent purchaseNewbie with a recent purchase
views 2097
replies 18
following 11
someotherguy
+1y
2. Door panel clips from any parts store. Power window buttons boneyard. They'll have to come from a 92-94 Suburban, 92-94 fullsize 4 door SUV, or up to 94 crew cab.
4. That fender is likely bolted on (I hope) and not just supported by tape. Would be way too heavy just for tape.
5. Wiper motor circuit board just needs to be re-soldered, crazy easy. Figure you already own a soldering iron; disconnect harness to motor, pop cover off the motor and carefully pull the board out. Re-solder the 5 joints where the harness socket mounts to the board. Spray some good contact cleaner on the 3 tabs at the corner where it plugs into the motor itself, and some in the socket too. Done. Turn signal probably does not cancel properly due to steering wheel way off center (due to tie rods adjusted wrong) or broken cancelling cam inside column.
7. A good center console can be tough to find; you might get lucky and score one for $50 or up to $150. The 94-down console is stronger than the 95-up so that's something going for you. Don't get one from an extended cab as they have a different floor profile.
Nice ride!
Richard
4. That fender is likely bolted on (I hope) and not just supported by tape. Would be way too heavy just for tape.
5. Wiper motor circuit board just needs to be re-soldered, crazy easy. Figure you already own a soldering iron; disconnect harness to motor, pop cover off the motor and carefully pull the board out. Re-solder the 5 joints where the harness socket mounts to the board. Spray some good contact cleaner on the 3 tabs at the corner where it plugs into the motor itself, and some in the socket too. Done. Turn signal probably does not cancel properly due to steering wheel way off center (due to tie rods adjusted wrong) or broken cancelling cam inside column.
7. A good center console can be tough to find; you might get lucky and score one for $50 or up to $150. The 94-down console is stronger than the 95-up so that's something going for you. Don't get one from an extended cab as they have a different floor profile.
Nice ride!
Richard
big bear
+1y
welcome to the site and truck is looking clean clean and sharp. did you get you little list of items all fixed up ?
bhb
+1y
Cool truck.
Needs some cab lights.
You can get replacement carpet from " target="_blank Go for the mass backing option if you do. If the carpet is not worn, you can remove the carpet and pressure wash it. I did this on my '89 and it came out really clean.
Needs some cab lights.
You can get replacement carpet from " target="_blank Go for the mass backing option if you do. If the carpet is not worn, you can remove the carpet and pressure wash it. I did this on my '89 and it came out really clean.
boatcrazy
+1y
Where can I purchase nice quality smoked cab lights as well as smoked dually fender lights?