bodydrop to lay yota bumper

How big of a bodydrop do you need to lay the toyota 4x4 bumper. Also how much is it to lay pinch/. I think I may just bite the bullet and bodydrop it

I believe its 2 1/4 to the pinch
you're more than likely going to have to streatch(sp) the toyo bumper to make it lay out hope this helps

2 inches to lay pinch james, thats what i did

if you cant get out a tape measure and find out yourself, do you really think you can figure out how to do a bodydrop?

Originally posted by MazberryDelight



if you cant get out a tape measure and find out yourself, do you really think you can figure out how to do a bodydrop?



Devin. haha! My interpretation =

valid point and funny as hell., but on subject its about 2.25 to the pinch and about 2.75 to 3 to the rocker, should lay a 4x4 bumper with the 3 inch bd i know you have to go to the door to lay a 2wd bumper, but once it lays you kinda wish it didnt.

frames 1.75"lower then the pinch so logic dictates that to lay pinch you need a 1.75" bd if your truck lays frame , now if its on 24' wheels it stillonly needs a 1.75' bd if it lays frame , same as if you run 13x7" wires

on my yota we z'd the front 3/4
we folded the pinch over
and we body dropped 2-3/4 since i plated the frame .
i have a 4runner bumper and its at least a inch to 1-1/2 off the ground. i imagine if i cut half the rockers off it would lay bumper. most yotas i ever seen on rocker didnt lay front bumbper at all

Thanks to all who contributed. but not devin. Anyways I can't go and measure cause I don't have a toyo bumper. Thanks
Jamie

Originally posted by bumlove_blue



Thanks to all who contributed. but not devin. Anyways I can't go and measure cause I don't have a toyo bumper. ThanksJamie

Devin was fucking with you! haha



-JONWR