welding in fillers

my 04 crew cab fixin some damage and at the same time getting rid of the gas door stake holes and the plastic on top of the bed rail theres like 14 holes under them and even if there welded up theres still a big lip

before

after

kewl .... had me guessing where i couldnt really see much other than it appeared to be a new chevy

Looks like ya done a real nice job on it though bro

thanks man

Seth was that a long bedside that you started with, just currious i understand what you did to get rid of the top but not sure about the way you seamed it but I did notice the gas door wasnt on the new bedside. Looks good though.

it was a six foot short bed bed side my left rear was smashed so i had to replace a side anewas and my friend had a bed laying around so i cut it up for my five and a half foot bed wich only comes on 1/2 ton crewcabs kinda like a ford super crew there shorter but you dont really notice i also cut the top of the other side off and used it and since the gas door lined up wrong and it looks beter with out i fliped it to the inside and i seamed it there cause it was to long plus it was easier to have some of the old panle for lining everything up