Page 7 of 16
Air Ride Suspensions \ ***Custom Frame******Custom Frame***
views 2959
replies 153
following 112
91 drggn dime
+1y
Originally posted by 1los10
ok whats the process i've always heard that its nothing but bad
i might leave something out, b/c i havent ever done it. but you can successfully weld to it, that is how civic spindles get sectioned to lay them out. Anyways, the process is.
heat cast to 400 degrees, then you can mig your mild steel to it, wrap it in a heat blanket, so it cools very slowly..
ok whats the process i've always heard that its nothing but bad
i might leave something out, b/c i havent ever done it. but you can successfully weld to it, that is how civic spindles get sectioned to lay them out. Anyways, the process is.
heat cast to 400 degrees, then you can mig your mild steel to it, wrap it in a heat blanket, so it cools very slowly..
lownism0
+1y
I was told to weld to cast you need to heat it red hot then weld it with a nickel rod then let it cool very slowly.
91 drggn dime
+1y
Originally posted by lownism0
I was told to weld to cast you need to heat it red hot then weld it with a nickel rod then let it cool very slowly.
^^ that is what i'd listen to, robbie went to school for this sheet.. i just learn from him.. haha
I was told to weld to cast you need to heat it red hot then weld it with a nickel rod then let it cool very slowly.
^^ that is what i'd listen to, robbie went to school for this sheet.. i just learn from him.. haha
impulse
+1y
Originally posted by 2lowastro
Originally posted by 2lowtoy
what is that IRS out of ?
Supra fool.
Originally posted by 2lowtoy
what is that IRS out of ?
Supra fool.
Pancho
+1y
turn the heat on your welder very hot and your wire low...we've been doing it for about 5-6 years never had a problem
