Easiest Drop/Cheapest

why be cheap about it? being cheap about things always leads to problems later on which means more money to fix the cheap things you did. i never understand seeing people cheaply do things and theyre confused when things go wrong or theyre not happy because its not what they want.

The front is cheap if you do the balljoint flip, but you'll have alignment troubles unless you do the upper control arms to fix the camber! Complete kits sell for just over 200 bucks, so tell him to hold off and just do it right!!! There's enough hacked trucks out there without doing it to another one!

-Phil at FBI

let the air out of the tires. can't get any cheaper than that.

Edited: 11/16/2006 2:45:01 PM by tuxlugz

do the ball joint flip in the front. flip both upper and lowers. if you dont flip the upper it will put too much stress on he ball joint. you don't need aftermarket upper control arms either... my alignment is within 1 degree of factory. do some blocks in the rear. (3-4 drop) then do drop coils/leafs and your notch (5-6drop)

you can probaly get all the grade 8 bolts you need and blocks for under $100.

check out www.customtacos.com in the tech section for more information

I wouldn't cut the springs but that is just me. Also you get what you pay for, might as well spend a little more money and get something that will last.

well he just purchased the 3/4 drop kit from stylinconcepts for $270.... so i guess if he wants to go lower i can use these other ideas for him... righ?? and again thanks for all the help ahead of time!!!

BUMP