Page 10 of 14
Toyota Trucks \ Custom Tacoma Spindles!!!Custom Tacoma Spindles!!!
views 2399
replies 134
following 79
taco2nv
+1y
Not sure if this is a stupid question, but is it possible for a uni-balljoint to bind? if you were to use your spindles on like an 18 would it cause them to bind? i had put my stocks rims and tires on my truck and when i layed out it would cause them to bind really bad after a few weeks of using my stocks i blew out one of my upper balljoints. if i used your spindle would it replicate this issue?
PimpinMidgets
+1y
Max, can you build a set of spindles if i was to send you my factory ones? or do you need the entire front clip?
BioMax
+1y
Originally posted by iownyou
Not sure if this is a stupid question, but is it possible for a uni-balljoint to bind? if you were to use your spindles on like an 18 would it cause them to bind? i had put my stocks rims and tires on my truck and when i layed out it would cause them to bind really bad after a few weeks of using my stocks i blew out one of my upper balljoints. if i used your spindle would it replicate this issue?
The way that the uni-ball will me mounted, there is no possibility of them binding. The Lower ball-joint will be the travel limiter.
Not sure if this is a stupid question, but is it possible for a uni-balljoint to bind? if you were to use your spindles on like an 18 would it cause them to bind? i had put my stocks rims and tires on my truck and when i layed out it would cause them to bind really bad after a few weeks of using my stocks i blew out one of my upper balljoints. if i used your spindle would it replicate this issue?
The way that the uni-ball will me mounted, there is no possibility of them binding. The Lower ball-joint will be the travel limiter.
BioMax
+1y
Originally posted by PimpinMidgets
Max, can you build a set of spindles if i was to send you my factory ones? or do you need the entire front clip?
If you send me a spindle, I can modify it to lift or lower the vehicle (usually) with out the frame or brakes.
Max, can you build a set of spindles if i was to send you my factory ones? or do you need the entire front clip?
If you send me a spindle, I can modify it to lift or lower the vehicle (usually) with out the frame or brakes.
FXDGRND
+1y
$600.00 for that? I bet you only have 100 or so hours into the design. And wtf is metal doing on suspension!
Looks killer max.
Looks killer max.
dragmatic
+1y
Once again it has been made very clear why Bobby and Max are two fabricators that I admire the most.
inomrthenudo
+1y
^^^^^^^^^^^^^^^^^^^what are you talking about? Bobby and Max are the worst fabricators! J/K Bobby does good work, he did my truck and will do my Tacoma when I get the dough. Good job Max on the spindles.