Brushed stainless fuelcell....

Edited: 11/23/2006 5:16:22 PM by grip

I built this cell for a customer that flaked on me and it's been sitting in my shop.It's one foot square by 27 inch's and has a 74 gm sender/pickup.It also has baffles and a plate to weld a direct pickup on.Best offer takes it.I am in the lower part of Oklahoma.Thanks,Grip of Form&Function//NC\\OKC

Nobody needs a cell?Not even a snide remark.

100bux, plus shipping?

thats the remark ya wanted...plus i'm in the middle of cuttin the truck up. fuel cell time.

A four by ten sheet of stainless is $484 dollars.You can get two tanks out of a sheet.I have no use for this tank so I would go like $300...

16 or 18 guage

14 gauge.

My bad it's 16 guage.

If given dimensions would you make another one? Probably get by with using the other half of the sheet.. dragntrac23@yahoo.com

Originally posted by grip

Best offer takes it.

Originally posted by grip

I would go like $300...

thats kind of contradictory isnt it? Like an ebay auction that says "NO RESERVE" and then you open it up and it says "a small reserve has been set to protect my investment"

Just giving you shit, bump for a nice gas tank. Those dimensions should fit behind an S10 rear axle, so you should be able to get what you want.

Originally posted by Dragntrac23



If given dimensions would you make another one? Probably get by with using the other half of the sheet.. dragntrac23@yahoo.com

Yes,if you give me your stock pump also bear in mind it has to be the same depth as your stock tank.Plus a little if you want a kick ass cap..