frame idea for my truck...

What does everyone think about this so far? It's just the rails, back end, fuel cell, rear end and fuel cell mounts. Im going back now to do the crossmember/driveshaft ring and 4 link mounts.

kool i like it.

the part where the fuel cell mounts, how it comes back to actually mount it, where it turns back will be pointed, I just couldn't figure how to do that much detail. Trying to figure how I want my tubing done in the middle to help brace the frame even more.

pretty dope.

the rails are obviously not the same height all the way through, dont know how to make them exact on this program, but hopefully someone can mandrel bend like that? anyone know? or will it have to be pie cuts?

update. not sure really how i want the driveshaft ring, but thats sorta what im looking at doing. obviously it needs more crossmember support, and it WILL get it. Im heading out and don't feel like messing with it til' later. the "hump" (driveshaft ring) will have a bent piece going under the driveshaft kind of enclosing it.

you wont need to pie cut that frame
you can mandrel bend that tubing and it doesnt crease

theres tons of frames like that

thats what i thought, i just didnt know for sure if you could get it bent up even with it vertical. makes it even better for me!

what u using for the 3d?
rhino3d?