HARDBODY REAR SUSPENSION

it will be hard to run a 3 link and keep the factory gas tank with out runing a pan hard bar because the gas tank to far to the center of the truck. The wishbone cant get enough of an angle to keep the axel centered

i built a wishbone on my old hardbody, used the stock leaf hangers in the front for the lower bars, and made a wishbone that had a bar parallel with the frame on the driver side about 3" from the frame, and a triangulated bar that ran from the frame pivot point to the top of the chunk on the rear end. i had to use different sized link tabs to keep the wishbone level, but it worked great, and i mounted the bags behind the axle.......

yes that would work not the most conventional method but it works

yes that would work not the most conventional method but it works

HEY CHRIS , DO YOU HAVE A DIAGRAM OF THAT SETUP, IT SOUNDS JUST LIKE WHAT I WANT TO DO IT BUT I CAN'T VISUALIZE HOW TO DO IT. THANKS

I agree with everyone who said wait and do it right. Just don't rush things, you'll be happier in the end. I like wishbone setups, I like seeing the different designs of how the upper bars can be done..