crzyone1013
+1y
the guy who did my alignment said my balljoints had been flipped but if they have i didn't do it. i don't know why they didn't make the caster the same on both sides, i guess they felt lazy. i am going to put the spindles on and crank the truck up the 2" it needs and mabye that will solve the bumpsteer. as for the caster i am not so sure until i switch control arms. i have another question. on the lower control arms there is a arm going from close to the radiator down to the lower control arms, that is for the caster, right? if so i know why my caster is off, its because of slamming the ground and sidewalks when i pull in somewhere that has a side walk just high enough to hit them. (me not paying attention sometimes) i have replaced them before because they were both bent before because of the hydros. mabye i will change them again. is there any way i can relocate these arms to a different location? i've seen some pics that look like the arms have been moved but i'm not sure how they accomplished this task. and also does anyone have any pics of how they redid the transmission crossmember to clear and lay flat? mine is still stock and before i wanted to go high so it wasn't a concern, not it is. does anyone know where i can get some good tubular control arms for my yota that i can lay 22's with for a somewhat reasonable price or good quality? thanks for all of the help.