Bagging an Accord (completed pics pg 3)

Edited: 8/21/2007 6:36:37 PM by CrucialNeon

This one is sitting on 20" HRE's Should be sick when its done

looks dope man.

delicious... i wish i had a garage id cut the shit out of my integra lol... but anywhoo hre wheels are bad as shit how much did those run him?

To be honest, i have no clue how expencive they are, but i know they are deffinetly not cheap. They are TRUE 3-PIECE rims btw

Gotta love the tear down pics

Had to get a before "trimming" shot

Here you can see where his Upper Control Arm has been Bottoming out on the top of the Strut Tower. Guess what that means................................

Had that same problem with mine...upper control arms was almost about to come through
before I finally cut it lol!!

well we are having some issues with the bags. The main problem is his car was slammed before the air ride & with this kit we can't get it close or past how low it was. So in other words its sitting higher than it was. Plus not to mention the front bags are rubbing the insides of the upper control arms & the brackets for it in the front. We talked to UAS & we are swapping over to cylinders! they don't offer sleeve bag kits so this kit isn't going to work at all

DOWN

UP

Since we have alot of down time, we decided to take advantage & start molding the gauge pod. Here's a couple of pics so far, wont post anymore till the pod is done

Lookin good!

Well today we got some of the valves mounted up behind the Rear Bumper. We plan on putting the other set on the bottom of the crash bar. We also made the new trunk floor piece. This new one allows the tank to be sunk into the spare tire well & also allowing it to still be exposed. Getting closer & closer to getting it finished, can't wait for the finale product