threads
Page 2 of 2
Mini Truckin General \  Frame differences

Frame differences

Mini Truckin General General Discussions
views 3815
replies 13
following 6
 
domepiece   +1y
I bought a front 1/3 of a 1st gen frame for $60. and all it was missing was brake pads. If you're doing a stockfloor you would have to cut the frame horns off anyways to at least move them down.

What are you trying to do?
unusualfabrication   +1y
I want it so I can throw it on a frame table and jig it up without the truck thats its going under. So that way the owner of the truck can continue to drive it until its finished.
domepiece   +1y
That's what i figured. It should work for that. You could always get it and have the guy bring his truck over and measure everything out to make sure. Hell you could even do the front frame horns and just cut out where the bumper bolts on and swap it over. As long as the core support mount are the same. Then sell his frame or use it for someone elses truck.
bdroppeddak   +1y
hey i did the same thing chris, i used a 1st gen to make a jig for a 2nd gen truck....