Page 13 of 18
Body work and Paint \ ****Project: "Bucket of Bolts"********Project: "Bucket of Bolts"****
views 4926
replies 171
following 59
granth
+1y
Edited: 8/6/2008 10:57:23 PM by 72bumpside
I heard you work slow but good.
your primer jobs look better than 50% of full paint jobs out :ROFL:
I heard you work slow but good.
your primer jobs look better than 50% of full paint jobs out :ROFL:
lost cause
+1y
Edited: 8/7/2008 8:09:26 AM by lost cause
And here we go again....the drivers door is just as bad if not worse than the passanger door..
Why do people think that bondo fixes rust well it doesn't!
anyways here is pics of the work that needs to be done to the driver's door
^^^G,.....I can't wait to see whats under this shity body line ^^^^
^^^^WOW!!!! ^^^^^Can we get some metal fab in tha house
The inside of the door had quite-a-bit of surface rust so I knocked it down and brushed on some por15 as far as I could get inside the door to help preserve the fresh metal
^^^^^Those are "lost cause" custom one off patch panels ^^^
And then the fun part,....MUD! hahahaha (And once again it doesn't need much )
There's nothin' like fixing somone else's half-assed shit work
And, Thanks for all your comments on the build guys! "Lost Cause"
And here we go again....the drivers door is just as bad if not worse than the passanger door..
Why do people think that bondo fixes rust well it doesn't!
anyways here is pics of the work that needs to be done to the driver's door
^^^G,.....I can't wait to see whats under this shity body line ^^^^
^^^^WOW!!!! ^^^^^Can we get some metal fab in tha house
The inside of the door had quite-a-bit of surface rust so I knocked it down and brushed on some por15 as far as I could get inside the door to help preserve the fresh metal
^^^^^Those are "lost cause" custom one off patch panels ^^^
And then the fun part,....MUD! hahahaha (And once again it doesn't need much )
There's nothin' like fixing somone else's half-assed shit work
And, Thanks for all your comments on the build guys! "Lost Cause"
lost cause
+1y
Here's what I get to deal with today
^^^^Belive it or not thats supposed to be a perfecty rounded corner
who knows WTF they did to get that nasty, pionty edge
^^^WOW,....who needs to cut your metal perfect when you can just beet it with a hammer and make an awesome body line
^^^^Belive it or not thats supposed to be a perfecty rounded corner
who knows WTF they did to get that nasty, pionty edge
^^^WOW,....who needs to cut your metal perfect when you can just beet it with a hammer and make an awesome body line
lost cause
+1y
^^^^Fo sho',.....you won't have anywhere near as many steps though
You should get a rendering done to build some anticipation
You should get a rendering done to build some anticipation
KEEF
+1y
brian the fun is just beginning man wait till the doors are back on the truck and u have to start grinding door edges and welding them back to get the gaps right, then theres the roll at the end of those doors that takes a shit load to make flat with fenders fun fun brother....Looking good man hope you are getting compensated for all the time goin into this one will definately be worth it to the owner in the end !!!!!!!!!!!!!