Yota 5 lug conversion

its russel i was talkin about

its actually layin in my shop floor, maybe ill take it and sell it to you haha

HAHAHAHA SWEET! Just be like "It was here a minute ago?"

So is a stamped steel housing rearend. I'd really like to get one of them. WAAAAAY cleaner!

If I can figure something out on gettin' it home I'll be on it like a $10 whore on $2 Tuesday.

thats fine. ill do the same to his new 20" KMC's if they ever get here.

yeh its a stamped steel one i think, i go look at it again

So as for bolting the yota driveshaft up. Does it line up or do you have to get a yota driveshaft and splice the front of the isuzu drivshaft to it or how does that work?

You will need a yota drive shaft or at least the bolt flange from it. If you have a reg cab measure from the trans output shaft seal to the face of the bolt flange on the diff, thats the measurement you give to the diveshaft shop. If you have a spacecab measure from the carrier bearing mounting bolts to the face of the bolt flange.