lowkid37
+1y
Edited: 2/1/2009 10:23:46 AM by lowkid37
Edited: 2/1/2009 2:34:59 AM by lowkid37yes it will be a three day june 19,20,21 at the mason county fairgrounds in shelton. we are expecting to be 100 times better than we have ever been. we are expecting some sponsorship from car toys and kube 93 and many other big guns this year so tell everyone you know. $40 pre reg and $50 day of show and $20 for a to pig. if interterested let me know.
Edited: 2/1/2009 2:34:59 AM by lowkid37yes it will be a three day june 19,20,21 at the mason county fairgrounds in shelton. we are expecting to be 100 times better than we have ever been. we are expecting some sponsorship from car toys and kube 93 and many other big guns this year so tell everyone you know. $40 pre reg and $50 day of show and $20 for a to pig. if interterested let me know.
airrideluvtruck
+1y
^ Do you have any fliers I can give out? Finshed all the fab work on the frame yesterday pulled an all nighter and sprayed the frame around 4am, passed out at 6am and woke up at 4pm lol, Started to paint and install the front end parts and I ran into a problem.... Im using AIM spindles and the caliper bracket is rubbing really bad on the outer edge of the rotor. Anybody else have this problem with these spindles? The rotor caliper and caliper bracket are 84-94 so are the spindles 84-94, the truck is an '83.
airrideluvtruck
+1y
Edited: 2/12/2009 4:25:46 AM by AirRideLuvtruck
Edited: 2/12/2009 4:24:11 AM by AirRideLuvtruckSo I got the brake issue resolved with some belltech spindles I luckily had layin around, and threw the other spindles in the trash where they belong....lol Anyways got alot done today, removed the third sump off the oil pan, ran all the air and fuel lines mounted the engine and trans, and set the cab back on for the very last time! Finally! Should see more progress of this now that Im done with school. Stay tuned and tell me what you think so far! And me...
Edited: 2/12/2009 4:24:11 AM by AirRideLuvtruckSo I got the brake issue resolved with some belltech spindles I luckily had layin around, and threw the other spindles in the trash where they belong....lol Anyways got alot done today, removed the third sump off the oil pan, ran all the air and fuel lines mounted the engine and trans, and set the cab back on for the very last time! Finally! Should see more progress of this now that Im done with school. Stay tuned and tell me what you think so far! And me...
lowkid37
+1y
we are sposed to get our fliers in about 2 weeks and i cold send some to you or somethin. the trucks lookin good man.
airrideluvtruck
+1y
Another big update got the trailer fenders installed two weeks ago, and Ive pretty much been wiring and plumbing since, finished up almost all the wiring tonight. I hope to get the interior in by tuesday, tomorrow I start on the bed.
airrideluvtruck
+1y
Whats up guys been a while since an update, I finished putting all of the interior back in along with finishing up all the wiring and bed framing since the last update. Today I put the truck up on jackstands and inspected everything and made a few adjustments got finished around 9pm and took it on its maiden voyage. All thats left is sheetmetal for the bedfloor black paint for the rims and install the hood, then it goes back to Pete. Ill have more pics soon, here's one I took tonight at the docks.