threads
Page 2 of 3
Mazda Trucks \  wtf no steel braided lines?

wtf no steel braided lines?

Mazda Trucks Make Specific
views 594
replies 23
following 9
 
suicidemazda   +1y
dude i need mad help, with that shit too. i cant even figure out how to hook up my fuel cell yet. lol but if anyone knows how to on a 86 mazda letme know plz
thatsmydawg   +1y
i dotn have my sender hooked up yet i should do that first i just wanted to get the truck running first and drive it and never get the sender in and run out of gas all the time sicne i didnt do it right the first time. i called jegs and they told me they cant help me pretty much. summit told me to buy a new elec pump and regulator blah blah blah
twotonemaz (johnny)   +1y
I meant we make a brake line kit for the mazdas. but to answer your other ? id run a -8 line all the way up to the pump from the fuel cell with a hose finisher. There isnt anyway to crimp a line on that barb that comes off the pump its a push on style fitting. My buddy ran his -8 lines under the truck to a bulkhead and finished it up with -6 to his pump.
thatsmydawg   +1y
i just see the -8 line run all the way to the front is a waste of money lines kinda expensive and if i run iot all the way to the ftont i need atleast 14 ft of it just to get to the firewallgiveor take a few inches deff over 13 ft though for each line
thatsmydawg   +1y
jegs sells a barb fitting that converts -8an to rubber line if i could get the fittings i would just do rubbers for now
twotonemaz (johnny)   +1y
I understand the money issue man. That hose is about 3.00 a foot so youd look at about 45.00 a hose with the fittings.
jsnpdy22   +1y
Pegasusautoracing.com sells alot of fittings. I have a fuel cell that has 8an fittings on it, i bought a 8an female to 6an male reducer, then ran 6an to my fuel pump. I used a red anodized pro clamp to clamp the 6an braided line to the mechanical pump. I also have 2 fuel filters and a pressure regulator in there also, but pegasusa racing is where i bought all the fittings and lines to plumb it with.
thatsmydawg   +1y
johnny whats 45 a line thats cheap im more worried about the fittings to convert my -8 an fittings to 1/4 and 5/16 and i cant find 5/16 steel braided so i think im going to have to hardline it and redce it here and there
RA JORDAN   +1y
your just gonna have to reduce it down with a couple of fittings.
thatsmydawg   +1y
but thats what im saying i cant get 5/16 steel braided line i dont think even if i could i cant get it converted from -6 or -8 an fittings to fit 1/4 or 5/16 line