josh
+1y
Originally posted by nitrousguy22
Y would you traditional it?? SF it with some 3"x4"x1/4" lower the cab mounts and channel the floor a little if need be in the spots where the floor board goes down the lowest its only like four spots and the top of the trans tunnel needs raised up by the firewall. Its a 100 times easier to do it that way then to trad it!
would i just cut a "window" out of the frame to put the 3x4x1/4 in it? i dont have the room to have the cab complelty off of the frame. just trying to figure a way i can keep the cab semi on and all the wiring hooked up.
i think the intake setup on the lmm and the lbz are the same. did they happen to lower your motor down or anything like that? i know your hood is about 1 inch taller then my hood.
thanks for the responses guys.
josh