info on laying out a ranger on 20's w beams

so i know everyone is going to say to to use a yota clip or a mustang, but i dont have the money for that, and i just got some 20's and im tired of lookin at it sit retarted and not low so i was wondering if anyone could help me out with some info on what i need to do as far as notching the tie rods and other things. Pics of suspensions would also help to. 

Lots of cutting, lots of camber. Notch for the tierods and for the beams. Do a search though the ford forum. I think Joel posted several pics of what your looking for.

my ranger is in the process of a sfbd set up for 20/22s w/ ibeams, when i get updates ill let you know and show the pictures  

drop beams,notching for them and tie rods,relocate radius arms,mod or get new trans xmember and a Z.

i will search for some pics,i did one about 5 months ago that layed on 20s

sweet..thanks for the info..cant wait for the pics so i can get started on it and have it done by tex mex

Edited: 1/12/2009 4:26:07 PM by iLLblazer

Edited: 1/12/2009 4:25:23 PM by iLLblazerdo a search for my username on rangerpowersports. I have build threads for all 3 I beam rangers Ive done, one was on 20s. On a side note, I wouldnt do it again. Save your money and do a clip. You'll be better off in the long run.

--------------------------------------------- Originally posted by lowjoe74 sweet..thanks for the info..cant wait for the pics so i can get started on it and have it done by tex mex --------------------------------------------- aight,im lookin. i have a few discs to go thru lol. and i agree with joel,with a clip you will have better geometry and wont eat out your tires as bad

so even if its not a daily think its better to do a front end swap?

it should be fine either way. just with a the Ibeam clip will have tons of camber