Page 3 of 3
Mini Truckin General \ post pics of minis with v8 swapspost pics of minis with v8 swaps
views 313
replies 27
following 21
astrowoody75
+1y
astrosafari.com. mini vans wirh v8 swaps are a big deal to some of these guys. check out the videos
achievment_farmer
+1y
most husrts and b&m shifters only have you drill 5 holes, 4 bolt holes and a cable hole then the brackets bolt to the bottom pan of trans and then adjusting for slack and boom you're done basically. nothing major to them.
most husrts and b&m shifters only have you drill 5 holes, 4 bolt holes and a cable hole then the brackets bolt to the bottom pan of trans and then adjusting for slack and boom you're done basically. nothing major to them.
tuckinlugs06
+1y
yea i got the motor mounts 85% done now just got get some parts so i can put it in for good and not have to pull it out for a while...im lookin for a mini starter for a sbc and a oil pan but it has to be for a 307 ...350 oil pans dosnt work for some odd reason..also looking for a 4bbl carb ...yea i didnt check the hood when i had the motor in but it may be a stock hood...not really what i planed but may just cut a hole and run a scoop ...the one thing ill have to have done somewhere else will be the drive shaft..i did have to cut the cowl for the dis because i got the all in one unit ...other then that just some firewall cuting and thats about it...also on my install the stock manafolds would not work ...but i found some hand made s10 headers that were on the motor when i got it seam to work not the best looking things but they will be something to go off of when i have some new ones built
yea i got the motor mounts 85% done now just got get some parts so i can put it in for good and not have to pull it out for a while...im lookin for a mini starter for a sbc and a oil pan but it has to be for a 307 ...350 oil pans dosnt work for some odd reason..also looking for a 4bbl carb ...yea i didnt check the hood when i had the motor in but it may be a stock hood...not really what i planed but may just cut a hole and run a scoop ...the one thing ill have to have done somewhere else will be the drive shaft..i did have to cut the cowl for the dis because i got the all in one unit ...other then that just some firewall cuting and thats about it...also on my install the stock manafolds would not work ...but i found some hand made s10 headers that were on the motor when i got it seam to work not the best looking things but they will be something to go off of when i have some new ones built
tuckinlugs06
+1y
what inline fuel pump should i use...what psi...i dont want to run the engine driven one ..just cause it looks beter without it
what inline fuel pump should i use...what psi...i dont want to run the engine driven one ..just cause it looks beter without it
Uncle Fester
+1y
---------------------------------------------Originally posted by low blazerHere's an LT we just finished dropping into a Mazda B-series ---------------------------------------------Pardon me I need a moment. That setup looks awesome.
---------------------------------------------Originally posted by low blazerHere's an LT we just finished dropping into a Mazda B-series ---------------------------------------------Pardon me I need a moment. That setup looks awesome.