97 c1500 frame 22's stock arms

thanks to all comments. I have trimmed upper a arm mounts so uppers have full travel thats needed. I have dehumped lowers, plenty of clearence, my lower cup is extactley 2" and I still need to cut down upper cups, what is the measurment I need?

Edited: 11/30/2009 10:58:31 PM by lowrthnu92

when you cut the upper cups cut the top at an angle if its not already

I need top cut measurements, AND do yall still have sway bar hooked up, or is it removed?

you have to fold the swaybar in half and the upper cups should be $1.00 tall.

the jokes are getting gay

lowers 1.75' and uppers 3 and i know it lays,,,, anybody else have measurements, My frontend is all apart, and when I put it back together I dont want to have to take it back apart again.

just cycle the suspension!!!!!!!!!!!!!!!!!!!!!!!!!!!!  remove the cup in question, compress suspension measure gap, cut cup to gap. done

tukn22inch----that sounds simple, but its not. I want to get max lift available! dont have frame table, truck is way up in the air on jack stands. the lower arms might get more travel then needed. thanks for the idea though

 POEPLE WITH 88-98 LAYIN FRAME. AND 22S. ARE YOU USING YOUR FACTORY SWAY BAR?