Drop Spindles to lay 22s on a yota

Lookin good Tony.. We need to get together sometime so I can check this thing out.

Little update.... I got all the welding done to the front frame section and got all the welds cleaned up. I also made new bumper brackets that mount the bumper to the radiator support instead of the frame. Then I got the truck torn down, back on the jig, and ready to cut the old frame section off. I should have the new frame section on the truck 2mro and will post all the pics then

comong along nicely!

I like how the upper bag mount flows into the upper a-arm bracket mount.

Chris and Robert thanks for the complements like I said its what keeps me buildin in this extreme heat. I think the heat index here was like 105 yesterday!

Hurray up and get this thing runnin already,  can't wait to see some more progress pics on it.

Edited: 7/27/2010 11:42:04 PM by DisseveredCustoms

I finally got the new frame section back on the truck and put all the old control arms and steering on. I also test fit the motor and trans that im swappin in and found out that the firewall and trans tunnel is goin to have to go. I am also goin to have to redo the steering tie rod ends and the linkage from the rack to the steering column.  Im stoked to have this much done but got lots of work ahead so stay tuned!!!

Edited: 8/4/2010 5:59:08 PM by DisseveredCustoms

Ok just got my camera workin again so here are the pics from the work ive done so farOut with the old and in with the new. I didnt take any pics of them but I made internal gussets to go from the old frame to the new..  Heres the big Hole I had to cut for the new motor!!  Here is the new transmission mount and one of the new motor mounts 

Edited: 8/8/2010 10:23:14 AM by DisseveredCustoms

New tie rod ends, machined out of 1 inch solid stock   

that looks amazing! cant wait to see it ra....  im gunna have to pick your brain some when i meet ya!