threads
Page 86 of 132
Mini Truckin General \  Michigan Metal Works ---- Updates : Please Read.

Michigan Metal Works ---- Updates : Please Read.

Mini Truckin General General Discussions
views 56690
replies 1319
following 232
 
jeebus @ mmw   +1y
A nice set of powder coated Ranger upper control arms. They have the Jeebus Joints in them, as well as added clerance built into them for a shock. No more excuses not to run shocks in the front of a ranger, getting these ready for a customer for next week, going to do an install in the shop with them, ill make sure to post pics.

post photo
post photo
post photo
post photo
post photo
post photo
okcustoms   +1y
Im sure bryan is real happy to have arms that will work, 3rd time is the charm.
clenzer72   +1y
I'm looking forward to the installed with shock pics!
tmiit71   +1y
im gonna keep an eye on the install also..i am able to run shocks with DJM arms...same camber?
e10pvmt   +1y
how much extra are the milled caps and lower rubber dust boots? Can you do them on a DIY jeebus kit? is there any kind of dust boot for a uniball i have already installed?
jeebus @ mmw   +1y
--------------------------------------------

okcustoms said:

Im sure bryan is real happy to have arms that will work, 3rd time is the charm.

--------------------------------------------

damn, didnt know he went through that many sets of arms.... im sure he will like these ones.



Taylor

jeebus @ mmw   +1y
--------------------------------------------

tmiit said:

im gonna keep an eye on the install also..i am able to run shocks with DJM arms...same camber?

--------------------------------------------

Camber will be a tad better, but to really fix the camber, the uppers need raised. I sell brackets for that tooo.



Taylor

jeebus @ mmw   +1y
--------------------------------------------

e10pvmt said:

how much extra are the milled caps and lower rubber dust boots? Can you do them on a DIY jeebus kit? is there any kind of dust boot for a uniball i have already installed?

--------------------------------------------

Currently, dust boots are not an option. I was working with a company called seals-it, and they were going to produce the boots i need for these, in 100 quantities at a time... now they want them in 1000 at a time, not sure how thats going to work.

I can do the milled caps on a DIY kit. TO my knowladge nobody else makes a dust boot for a uniball.



Taylor

e10pvmt   +1y
ok cool...i will be getting with you soon...i just have to figure out the route i am going.....i need new upper front arms basically 9" center to center but the cross shaft has to be 6" on center with the jeebus to fit a pre taco spindle....but i think i want tube over flat....same for the rear but i need to get measurements and the angle the cup has to be at compared to the rest of the arm and the jeebus just a straight 9/16....just have to decide if i want to do a DIY setup or have you build them....i will let you know
jeebus @ mmw   +1y
no problem.

I build tube arms as well, all you gotta do is ask!



Taylor