F150 by Tre5 Customs

Build-Ups General Discussions

replies 162

following 58

juicedwagon +1y

cant wait to see more. the rendering looks so sick!

Marcos_65 +1y

You should get your own reality tv show.

98FRMED150 +1y

what are you goin to do about the rear crossmember that holds the rear cab mounts? about to start my back half and wondering what i should do.

tre5 +1y

I just cut it out for the drive shaft to pass through. The cab mounts are just as close to the frame as the ones that hang off the outside of the rails. There is only about 12" from that one to the one I posted a picture of so I am not concerned with having the cross member connected in the middle. I would have to cut into the cab to make the cross member connect and have enough clearance for the drive shaft. If you are not going to run 24s at anytime, there would be room for connection, but I probably would still just cut it out and not worry about it.

98FRMED150 +1y

ya im setting it up for 24's...just wondering if there was any concern about it...maybe ill do a simple plate on the sides just for insurance. thanks!

tre5 +1y

Getting the rear suspension on. Hopefully fully welded and spray bombed by end of the day Monday...