2 questions

3/4 single wheel rotors go right on my 1 ton spindle... what didnt work??

The offset of the rotor surface would not line up with caliper almost as if they slid on too far, all the bearings and seals were interchangeable so I figured there was an issue with the rotars. The back side of the rotor hits the spindle. I bought some SRW front rotors and it worked just fine.

U could just shorten your factory arms? or What I want with is 3/4 rotors and longer arms....3/4 sucks your wheel in like 4" or so?...so i had arms made to push them back out like 3"...so i ended up with a shorter arm!

^^^^ So some 2" shorter than stock BLF control arms would not require me to mess with the hubs, correct?

Hub?? U need 1" 1.5" Shorter arms just so your lugs dont hit your fenders....Ask Shady he made shorten arms layin frame on 24"s