Page 1 of 3
General Discussion \ Immortal1 in the houseImmortal1 in the house
views 4280
replies 29
following 13
immortal1 (linn)
+1y
Altered Images VP in the house
Pic of my show dawg that I've had since it was brandnew in 1990
Pic of the 1988 Mazda which I am building for my daughter.
Will probably be leaving many posts now that I have found this site.
Pic of my show dawg that I've had since it was brandnew in 1990
Pic of the 1988 Mazda which I am building for my daughter.
Will probably be leaving many posts now that I have found this site.
mark
+1y
welcome to the site bro.
looks like you got a lot of experience under your belt!
what a lucky daughter you have as well lol
looks like you got a lot of experience under your belt!
what a lucky daughter you have as well lol
nytrdr24
+1y
welcome to the b-scene!!
'bout all i can say is.... DAMN YO!! SWEET RIDES!
your daughter is very lucky to have a kool dad!
(crowd chearing) more pics, more pics, more pics!!
'bout all i can say is.... DAMN YO!! SWEET RIDES!
your daughter is very lucky to have a kool dad!
(crowd chearing) more pics, more pics, more pics!!
immortal1 (linn)
+1y
(crowd cheering) more pics, more pics, more pics......
Try this link.... should help for a while.
will post some more of the project DawG.
I am sure somewhere in MazdaBScene there is some info on drop spindles pros/cons. Have a set of Chassis Tech drops on the way for the project. Don't think I will have the usual problems as the uppers and lowers have been extensivly massaged
Try this link.... should help for a while.
will post some more of the project DawG.
I am sure somewhere in MazdaBScene there is some info on drop spindles pros/cons. Have a set of Chassis Tech drops on the way for the project. Don't think I will have the usual problems as the uppers and lowers have been extensivly massaged
nytrdr24
+1y
thanks for the link, when i get a spare min, i will deff. have to check them out....as for something on the spindles, take a peek in the suspension section....don't really recall an indepth discussion on them, could be a good thread to start....i dont' know of any draw backs right off hand except for you can't run deep dish wheels or any with a huge offset with them......though this problem could be solved by having them cryotreated...
thanks for the link, when i get a spare min, i will deff. have to check them out....as for something on the spindles, take a peek in the suspension section....don't really recall an indepth discussion on them, could be a good thread to start....i dont' know of any draw backs right off hand except for you can't run deep dish wheels or any with a huge offset with them......though this problem could be solved by having them cryotreated...