Factory 6x5.5 Steel 20"s?

Im kinda torn between giving my truck a prerunner look, and slamming it again..but im leaning towards slamming it..when its slammed i almost get 700km/tank lol. so thats sweet.

If i convert it to the Toyota 5 lug can i use the dodge spare 20"s??

those wheels you found look sweet and thatyw ould be some thing different on a mazda I don't think I have seen them before on a mazda.

i dont know if you can not sure if the patterns are the same, plyus ytou have to think about offset

hrmmmm i wonder how those 20s would be offset wise, it says theyre +18

I doubt they'd tuck well.

lool Pepehn, you're getting as bad as me I've been up twice, and down 3 times...and currently still down. Yet I'm considering going back up again lol, this with bigger tires, and a body lift eventually.

Wanna drop yours the right way lemme know, I got DJM arms and Bell Tech leafs

i was wondering that also, i been wanting some torq thrust for a while.

whats the offset and width ratio on navigator 6 lug stock wheels.

keep this is in mind:
for tucking on a mazda with 2WD sheet metal: a 7 inch wide wheel you will need at least +33, a 7.5 at least +40, an 8 at least +47 an 8.5 at least +54, etc, etc, etc. This is also just basic information and I'm sure you could get away with less offsets, but those Torqe Thrust's that are 8.5" wide with a +19 will not tuck.

have you tried looking for escalade spares? they might have 20's

nope i have seen an escalade with stock 20's or 22's in the mall parking lot.