Project Low Dime.

Damn bro that this is comin out nice !
keep up the awsome work and feed our greedy little minds with them pics we love pics

Hey Lucky, some of your shots are a bit blurry, Can I offer some tips on shooting?
I value your posts here and I would like to see the detail in your pictures. I sell cameras so I know a bit about them.
I would set the focus to auto if yer a newbie, be sure to hold the exposure button down halfway until the camera says its ready, usually you will get a green circle on the screen, or a beep or something, and then take the shot, that may help unless you were just drinkin too much coffee and ya got a lil shaky, lol. Thats what happens to me, If you tell me what camera you have I can probably help a little more, Ive sold every major brand over the last 10 years.
PM me and I'd be glad to assist if you would like.

I LOVE pics!

yea my battery that time was a little low so it takes blurry pics when its low, thanks for the helpfull tips, ill try those next time...oh, and its a kodak easy share, 4.0mp.

lookin good! nice pics of the progress.....you've had your hands full to say the least, wish i had the time to work on my truck like you've had on yours....be carefull with all the rust, it would be beneficial if you were to knock off what you can of it & apply a rust stopper, then seal it w/a rust prevenative primer.....otherwise all of your hard work will be neal when something breaks....better to fix it while you got it down this far, keep up the good work!!

gotta trim the cups a little and then it will lay out.

Love the 82 Madona tit gauges.

lol yea^ i can stare at em all day long

lookin good man, came a long way so far, i got the same steerin wheel

heres what i got done while i wasnt at school today;)

got it out of the garage last night with the help of a few friends, so i can work on flat level ground.


all wired up (almost)


started to get the lowers on...




bag plates...




then i started on the upper bars and made a new driveshaft notch.




wadayathink?