Mazda full Engine/Transmission swap

atkins rotary maybe?

It doesn't appear that they sell full rotary engines I want to by a full rotary engine

i swore that Dan did sell engines. Over on MT the owner of Atkins Rotary is a member, goes by Atkins_Dan. Try dropping him a message there, I'll tell him about this thread here as well.

The 13B and the 20B will work with your transmission gearbox, but you will need to swap your bellhousing with a rotary one. To the best of my knowledge, it is the same bellhousing used between the 13B and the 20B, Dan will know the answer to this. I'd use the RX7 gearbox though, gonna be stronger with better gear ratios.

Here is a link to their vendor forum on here:

" target="_blank

You can click Atkins Dan to message him on here or post in his forum.

My bad, I didn't realize that Dan was over here as well. Sorry Baha.

what year of block are you looking at installing???
as for a complete block what do you plan in using for an induction (intake system)??

Depending on how you mount (and where) the engine in will be a big factor on other parts of this swap..
Here is a link to my 1st B2200 rotary swap..
" target="_blank

the next truck that I dont have the time to finish right now I have too many tickets and with 2 kids not enough time.
I am using the same transmission from the 1st truck I built and I swaped the tail shaft housing & shifter fingers from the truck transmission to the Rx7 transmission.. in doing this I was able to use the original truck mounts on the transmission and drive line.. Now the Engine mounts will be tricky as the ones I am using the guy does not make them any more so you are on you are on your own there.. in less someone is remaking them..

So back to the top of my post.. what are you planning on doing for the intake and plans for the truck later on??

Dan

Cool would you suggest just getting a normal engine versus Wenkel because I heard that rotarys tend to blow at low mileage.

I plan on making my own cold air intake and maybe if I feel up to it a turbo intake something cheap and good though.