What are you doing/did you do today?

I've done those jobs on my B2200, pretty straightforward because the ball joints are bolt-in. For my lower ball joint (so I could screw in a grease fitting into the tapped hole), I cut a small recess.

I use a small puller that I bought from AutoZone (finally bought the tool after 3rd time using as loaner tool).

well we were suppose to have gotten snow today only some flurries so looks like ill be getting started steering project early Sunday morning

Got pulled over in the new mazda last night for clear tail lights so went and got new led red bulbs for the brake and tail light bulbs. Theyre fucking expensive but i think itll do the trick!

Going to north dakota saturday for two weeks so tryna get everything done around the house before i leave. Sucks

Fu

i so want those LED bulbs and yes they are expensive but they are a little cheaper online i thought i saw them in autozone for like $30 for 2

Ya i bought leds for the brake and tail lights. Was like $50.

Was going to get them on ebay but i wanted to drive it before i leave for nortb dakota. Also really need to get it registered today or tomorrow lol

Well it isn't really from today... But it's recent




Compression test results...

Cylinder 1

Cylinder 2

Cylinder 3

Cylinder 4

Numbers weren't the greatest but considering the milage of the motor, and the age of it... I didn't think it did too terrible



Fred

Sent from my SPH-L710 using Tapatalk

Not from today, but from this weekend.....

Looks good

thanks, this is the first time the front end's been off jack stands in about a year..