threads
Page 4 of 4
Mazda Engine General \  curiousity what other engines do we have for options ?

curiousity what other engines do we have for options ?

Mazda Engine General Mazda Engine Mazda Tech
views 7357
replies 38
following 24
 
hybrid   +1y
ok i have a corvette lt-1 that is planned on going into my mazda,i have a whole car to use,it a 1994 chevy impala and i am wondering about wiring.the good thing about this engine the distributer is in the lower driver side of the motor under the water pump.
trashed   +1y
will a 2.5 jeep motor work?
lomazda92   +1y
I'm sure a Jeep motor will fit and work but WHY?
f n lo   +1y
i got a mazda mx-6 engine i want to put in, but the ditrbuter in facing the firewall, being as im goin to put in a new dash, i think i mihgt tub the firewall, anyone noe why this wouldnt work? its the plder mx-6 enigne, i got a turbo and everything for it, if i end up not doin the block, im going to rebuild the engine i got, and put the turbo in the original engine.... any help would be great!!!!!!!!!!!!!!!!!!!!!!!!!!
baggedb22   +1y
I think u can run a fuel injected mazda head and intake so keep the distributor in the stock location
baggedb22   +1y
but dont take my word for it im a v8 guy no boost for me =)
f n lo   +1y
wel my enigne isnt the best so id do a whoel rebuild, but u think my engine would be alright? i think the stock mazda is 8:1 if im right and the mx-6 is 7:1.... if i used the stock block would the mx-6 head fit on with no problems?
b2200gt   +1y
This might help with any Probe swap questions:
kyle rimer   +1y
is there any motor that would fit on the tranny ? what all would i have to change