threads
Page 2 of 3
Mazda Lowering Static \  bad mo fukka

bad mo fukka

Mazda Lowering Static Mazda Suspension Mazda Tech
views 3400
replies 22
following 9
 
slammed91b5000   +1y
i have that compressor as well and i have a 135 amp 1 wire racing alternator and 2 optima yellows and it cant keep up some times when i get switch happy. that thing will fill a 7 gal tank form 0 to 150 in like 45 seconds but it draws like 200 amps. thats more than a starter. so think about how fast your batteries dies if your car wont start and your running your starter for like 45 seconds.
mark   +1y
how much do those GM alts run at an autoparts store like autozone?

i heard there was car with a GM 1wire and it was 35bucks or something after a trade in

or i could snag one at my local pull a part for like 10bucks...that would help a lot, cause when my lights, compressor, radio , and turn signals are on...everything dims and the compressor sounds like its about to croak at idle lol
low87dawg   +1y
damn did i buy a frekin honda motor to run my air??
baggedb22   +1y
Yea i'd like to have one of those compressors im also running a GM 1 wire alternator in my truck!
low87dawg   +1y
was that hard to do??
baggedb22   +1y
Nope, but i have a v8 in my truck.. If you get a 1 wire it's really easy all u need to do is fab up some brackets!
low87dawg   +1y
what bout the belt will that work it or do i change pulleys??
mark   +1y
you can swap the pulleys but you dont really have to, because the belt pulley on the GM 1wire has a sharper V, the mazda belt will not sit directly flush on the pulley, it doesn't hurt it really, just has a tad more wear on the sides of the belt because it isnt sitting flush
low87dawg   +1y
well what if i swaped it does it fit right and is it bout the same size??
foesicks   +1y
slammed91, where did you get your alternator and how much? and you got a 302 right?