wtf? wats happenin with my backend?

not that i notice. i dont bottom out much.

did you happen to find a stamped gate in the back of your truck any time lately ? haha enjoy

try to unbolt them and see what happens. is your lowering block centered on the centering bolt thru the springs?
is your rear shackle bolt too tight so it won't let the spring move like its supposed to?
are you sure it's your frame that's sitting high? maybe your bed is crooked?
are your torsions turned equal amounts in front? maybe one corner is turned more than the other and its squatting more there and you just notice it more in the rear?
man i'm racking my brain and trying to suggest stuff to you.... i'm runing out of ideas... except... wait i think i got it......
JUST BAG IT!!! that's going to solve all your problems. a nice 4link and bags.

First off....Check your work and see if everything is straight. Ok try this.......measure the front to see if it's leveled. The driver front might be cranked down too low. Crank it up to see if the passenger back will level out. Let me know.

wow i wishi could bag it speedster. well i no the driver side is a lil lower because i reindexed the torsion bar on that side but i couldnt get the passenger side out. but theres not much of a difference. i tried to fix it today but my driveway is so f**k'n warped i can jack the truck up. i hate my driveway.

hmmm.... sounds like that might have something to do with it eh? either do the passenger side or undo the driver side and i bet it'll level out a bit. just think, 1/8 of an inch difference magnified over the whole length of your truck can equal out to several inches by the time you get to the rear...

i guess ill get to it sunday or monday wen i have time and see how it werks out.