Need advice to lay frame on 20s...

you dont actually flip the lower balljoint completely over. just move it from bottom to the top.





-justin

when you run toyota spindles you have to flip it physically over... and im gonna put it on the top side of the arm too... see look at the diff in the spindles, the toyota one is on the left..

i still dont see why you have to physically flip it over. could you explain it to me? im just not seein it. lol





-justin

if u just move the lower ball joint then the lower control arm would be raised up so high that you would not be able to fit a fully compressed bag in.....you have to completely flip the ball joint to allow the lower control arm to stay in the stock location......im not a 100% sure but this is my understanding

no... the toyota spindle is made differently so that physically flipping it is required to accommodate the spindle.... the toyota spindle is on the left, mazda on the right... notice the lower ball joint mount on the spindles...

o ok i see the flanged part is flipped on the yota spindle....