Just got my first mazda.Sold :(

hmm aluminized, wouldnt that just be a coating? could i weld to it with my welder? its not an aluminum welder....

thank you, it'll be on the gorund sooner or later, lol it's not leaving y garage until it can scrape all the way out!!!

it will prolly be later than sooner though


-justin

haha yea, as money permits, i have time just no money haha

im in the same boat. my compressors came in yesterday and now im buildin the wallet back up for some more parts.



-justin

for sure, lol everytime it builds up for me its bill payin time lol

everytime i get a lump sum at one time whether selling something or something like that. something always happens. like when i wrecked my bike and got like $900 it was time to tear in to the truck but then i got laid off. bummer



-Justin

Yeah its just a coating to keep it from rusting. Most exhaust components are like that. You won't have any issues.

sweet stuff, thanks man

so today i started back on grinding my notches and decided fuck this lol its under the bed anyway, and the bed isnt coming off at any shows, so i ground down the visible parts, and im not exactly building a "show" truck its more my truck, lol, anyway decided to put my grinder to good use, got the wire cut brush, and holt hell, i starte on the back corner of my bed, i knew bondo was there, and whomever did it put too much on and didnt sand enough off, it bubbled out so it was noticeable, anyway never seen so much bondo on anything, that rear panel is pretty fuckered up though, they tried hammering it out i think with like a normal hammer, its so bad, i will try and smoth it out as much with my ball and hammer, but mainly bondo will be good lol im pretty decent with that stuff, hard to see in the pics but you see all the dust everywhere, i didnt wanna stop to get the camera and take a pic half through it was seriously an inch thick at least...