Truck is in the garage!

Not too much not too little. I think like frame clearance to ground is around four and a half maybe five inches at 60 psi. I'll have to check
when I get home.

sounds like the bridge and upper bag plates could go down a bit. how well do you have the bridge welded in? it may be good to cut it back out and lower it a bit while you wait on metal to get here. just my opinion though.



-justin

What is it at about 20 PSI? Thats about where it will ride the best, with a decent shock set up correctly.

No cause if I move the plates down then it will bottom out the bag befor the frame hits the ground. You don't get monster lift with over the bag setup. I don't want alot of lift. If you want lift do bag on bars.

oh it just looked like that the bags werent fully decompressed when layed out. my bad.




-justin

I'll see when I get home. Im still at work. I'll post some psi's and measurements.

The RE-8's have an internal bumpstop and are 3" compressed.

Ok I might have been a little off before. 20 psi puts me at four inches off the ground.

all the slam bags are 2.8" compressed.

ok, my bad 2.8". Thats what I get when trying to compress it with one knee and measure with a tape measure! lol