Truck is in the garage!

i dont see why it would hurt to do your bridge. i wouldnt do the bag brackets though until the 4-link was set.



-justin

Well I took my leafs out and tacked up my bridge. What do ya think?

Ha! now that I think about it the cross member is supposed to be in the back so it doesn't hit my upper link bars! De De Dee! Looks like I have something to do tomorrow!

Never mind I measured and it should be fine. They make bridge kits that have two bars front and back. Anyway my frame will be on the ground before the bridge even gets close to the bars.

looks good man, and yeah your bars shouldnt even come close.

can we get a close up pic of your welds? just wondering what is up with the white.





-justin

nice job hope my build will come along just as nice cant wait to get where your at.

Im using fluxcore wire. no gas. Thats what the white is. It smokes like crazy!

well i have done alot of these trucks this way and I haven't had a problem yet but you also must know that the frame is not perfectly straight back it is cocked alittle. i understand that the rear is not totally cantered and sometimes truing them up makes more problems down the road with the drive shaft but either way works.

okay just checking. i've welded fluxcore for a few years and have never had as much white as you have. most likely just some impurities in the metal. lookin good though man. ready to see the rest of the build


-justin