PROJECT:- SETBACK

woot! got something done for a change

finished up the lower bag brackets first


then I threw in the new front x-member and cut the old one out so I could get the upper links in.
got the lower bag plates welded on too. But I ran out of time before the rain came to finish the rear cross member that will replace the spare tire mount

Looking good Sleepy! I finally get to drive mine, I got it registered and insured this past Friday, and got the plate mount fabbed up yesterday. I will post some pics up tomorrow. I don't love it, but I did not have to cut up my skin to do it. Keep it up though Bro. -Ed

Looking good Sleepy!!

kick a$$ man

looking good...how much pinion angle chage do you get

to tell you the truth todd I have no idea, I don't have a degree finder yet. I setup the links with 3" of frame clearance from the ground. I also used 4-link calculator to design the parameters, which made me have to shorten the uppers one more time. when I tacked everything one I kept the axle at the same angle as it was when static, I never had issues there so I went with it "for now". By the time I get it ready to be on the street I should have a degree finder and be able to make adjustments if needed. I also noticed I need to notch my front cross member for the driveline before I can put 18's on it, but only about 5/16th's

thanks for the reply's guys, probably wont see much more till next weekend or so.

Looks good man! ! Keep it up! ! !


-Josh

pics pics pics

well as promised I did something to it again this weekend. I am trying to work on it every sunday for now, got other things that pay me so I have to work on those first.

but anyways how bout some pics
I raised the bed floor for the Z and added 2 more inches for the BD

looks awesome man. . . Very excited. . .


-Josh