custom motor mounts....

im putting a b2600i motor in my 89 mazda b2200. has anyone done this swap before? if so what did you do for motor mounts?

Arent they the same? I dunno Im jus sayin, lol, My bad, But I honestly think that they are ther same, If not. Then take em off a 2600 and bolt em up to your 2200 (frame side)

the b2200 mounts are smaller than the b2600 mounts.

Hmm, Do the motor mounts off the 2600 unbolt from the frame? I know on like Chevys and stuff you can just unbolt the mount from the frame and bolt it up to abnother frame, Thats how we swapped out a v6 for a v8 in my buddies c10. Just throwing ideas out there. Seth can prolly make em for ya though (twistedminis) hes basically a badass lol

They dont unbolt on a b2000 with a 2.0 or a b2200 with a 2.2 so i doubt the 2.6 mounts unbolt

oh well, sorry man, Was worth a shot!! good luck bro!

the mount purches on the frame dont unbolt. their welded on the frame.

Cut them off and weld them on the other frame?

thats what i am doing they were pretty easy to cut off.

The piece between the motor and the frame mount unbolt. It is isolated by a rubber mount. I would imagine that is interchangeable, or easily modified to work. The mounts are only held on with 1 bolt on the frame side.