droppedmydawg
+1y
That was before I ran the lines up to the gauges. I just put a piece of line in there so I could go up in the mean time. They are run up to the gauges now. -ED
That was before I ran the lines up to the gauges. I just put a piece of line in there so I could go up in the mean time. They are run up to the gauges now. -ED
shilaeli huggr (burdaddy)
+1y
damn dude i love that wishbone set up. just wish i had a better job or less junk to tinker with so i could git started on baggin mine.
dirtracer14
+1y
Trucks looking good. I used the same wire block in the back and it is also stainless. I was gonna cover mine but after talking to a few guys around my area and they have no problem. Drag vids rule!!
droppedmydawg
+1y
I flattened out the flaps edges and then cut out some of the bed metal behind the flap and flattened that out too. Ground to fit and tacked it in. I still have a ton of welding to do on that.-ED
I flattened out the flaps edges and then cut out some of the bed metal behind the flap and flattened that out too. Ground to fit and tacked it in. I still have a ton of welding to do on that.-ED
droppedmydawg
+1y
Where did you think I got the great idea from?
Here is some pics of the truck out front. I went a little pic crazy, but figured no one here would mind.
Pulled out front, not all the way up, about 80 psi
Dropped the a$$ down
And layed out!
Anybody got a grill emblem they want to sell?
Where did you think I got the great idea from?
Here is some pics of the truck out front. I went a little pic crazy, but figured no one here would mind.
Pulled out front, not all the way up, about 80 psi
Dropped the a$$ down
And layed out!
Anybody got a grill emblem they want to sell?
Post was last edited on Jan 29, 2009 04:01. This post has been edited 1
times.