Ricks 1992 B2600 Project "Gold Finger"

im just talking bout how the back panels overlap and the padded back panel fits onto the truck. hope everything fits like you want it to man. its all good cause since its gonna be "custom" you can do it however you want to. as far as the heat goes if you dont want heat thats cool but you gotta think about defrost and other things you might need. it doesnt take that much to make the factory core fit again and everything will work like a champ.

ya defrost would be great but the dash is getting the works too so there wasn't any room for the luxury stuff like heat haha and if its a problem i can pull the dash and make it fit once again

I like the rear panel though!. it went back together rather well looking at the pics. When I did mine I did the over lap as per every guide I found and it fit like crap, but now I have a slick rear wall thanks to that, but no mounts for the rear seat stuff I'll just bubble wrap the kids and cinch them down with tie downs...lol

OK so we did some more work today and i had to move the clutch master to fit my rims so this is what i did i used mazda2guy idea a tweaked it a bit so here are the pictures

this the whole thing welded up

another view


with out the stuff on it

and here we go all test fit in side the cab we had to make a little room under the wiper cawl so we just bump it with a hammer to fit the arm better
well keep checking back

looks good man

we did ricky bobbys truck and my truck in like 3.5 hours. same setup for both and they work sweet!!!

im glad i could help props go out tuckin20s for the pics that made it happen

thanks for both of your ideas guys really helped a lot

No prob man anytime....

ok the tubs in the front are done so here is what i did for mine

this is the driver side done. notice i had to clear for the pedals and they do clear i will have to modify them some more cause im a bigger guy but i did clear for bigger tires


this is the passenger side


and now what they look like together