<>Roadster Show Mazda<> 86 B2200 rebuild update 3/4/13

Looking good. <><><> Nice wheel, is that the Edge? Same one as mine. You bringing it to Sema?

Its the Vintec but the two of them are pretty close to each other, and it was suppose to go and when they cut spots I gave my spot to another member in our chapter because he had more riding on it then I did, I got offered a spot with minitruckin but turned it down because I had already changed all my plans around to not take it.

Your Mazda is definitely on another level, love the new paint, interior etc etc etc!

Do you have any plans to put more power in the engine bay?

Thanks! I have thought about it but it wont be for a while, I have another project to start here soon, once its rolling i may do something in there but not sure what.

Damn Brotha! That new dash and the interior looks great! Really brings it all together! Loving the truck like always but it is definitely better than ever <>

Hey Jason i had a few questions on your irs setup.

Did u have to get shorter axles? I pickep up a tbird irs as well and was looking at it closer and its awful wide.

They were already shortened when I got it, they cut them and put a piece of tubing over them and plug welded them, so far no problems with them. they could be a little longer for more travel but I didnt want to buy new ones to try it.

Do u mind sharing pics?

I looked through what i have and this is the best i have right now, you can see the plug weld just below the boot and if you look close you can see the edge of the tubing, this is what it looked like when i got the frame to start on it.

cool thanks for the pics! imma give it a shot. i had spoken to you about this a few years back at Logan but i doubt u remember.

i may steal some ideas, but ill try to keep it as original as possible.

thanks again!