Project: Half Breed!

oh and have you run into a problem with wheels/tires not fitting up inside your wheelwels on your bed? if so...how did you fix it. my titans wont fit up inside my 2wd bed. i was told that a pre95 pathfinder axle was narrower but i measured it and it was the same. im thinking i just have to flare my bed...

yeah mini truckin had a how to on flarin ur bed. pretty much just a scissor jack and a 2x4. lookin good tho man.

use a older mazda or a non ifs toyota rear axle there both narrower and 6 lug

well i cut those two braces at the top of the wheel arch out of one side and i think i can just weld in some new braces and get enough clearance. i only need less than an inch per side.

got some work done to the truck today. got started on putting my notches in. the driverside is tacked in. then ran out of wire... bummer. gonna try to get some pics up in a little while.

Damn man looking good. I like your rear set up...clean.

yea makes me whant to loose the stock tank and go crazy

thats real clean speedster... looks good

yea im glad i dont have mine. i cant imagine having to f*ck with that.

this is my notch tacked in