Haters Delight (update 8/18/13 Ls swap) video page 9

truck looks good but i would spread the hinges farther apart down the road you find that the door will sag and you will go through bushings alot atleast 12 inches apart would do wonders

The jambs arent wide enough I would just leave them as is because Im not going to totally redo the jambs and the doors just to make them wide. Plus these doors dont weigh anything really.

i just re read my post....not made to have the hinge in the back

They are reinforced on the inside, they dont move at all.

good did want you to have probs later man

great start man nim digging the headlight conversion as well

Leafs are off, cut out anything not needed I will be raising the tank 1/2" or more.

Rear end tacked for now so i can still move it around.

Well this week is like an early christmas, by friday I will be ordering a wishbone kit, bridge kit, front bag plates, and front and rear bags. If anyone has temp lines for testing the bags that I could buy or borrow let me know will need them for 2 shows in august.

Quick question, as I've done no bagging yet. It almost looks like you tacked your rear axle to the frame, did you? And, why didn't you leave the axle attached to the leaves and then install your notch before removing the leaves? In my mind, correct me if I'm wrong lol, the leaves would have kept the rearend located where it need to be until you were ready to remove it.

correct but i will be setting the pinion angle at ride height which axle on frame is where i want it. I tacked it so I can roll it around still. I dont mind measuring.