threads
Page 2 of 3
Mazda Engine Performance \  Alternator

Alternator

Mazda Engine Performance Mazda Engine Mazda Tech
views 4456
replies 27
following 3
 
codywayne718   +1y
Thanks!
dealwithit   +1y
the only thing needed to get the ford 3g alt working is to put a 500ohm resistor in the signal power wire before the alt to drop the voltage abit. all it takes a little 1/4watt or 1/2watt electronics resistor to do the job.
codywayne718   +1y
Alright, alt finally took a poo on me. Looking into the Ford 3g alt. The smallest 500 ohm resistor I can find is a 5 watt. An they all seem to be for motherboards that you would solder in place.... Am I looking at the wrong ones and is a resistor necessary? Sorry to bump an old thread!
codywayne718   +1y
Why is a resistor needed to run the 130 amp?
codywayne718   +1y
Bump
codywayne718   +1y
Will an 88-90 100 amp Taurus one fit the same but without the need of a resistor?
codywayne718   +1y
Somebody? Anybody?
sincitylocal   +1y
I don't see any reason a resistor is needed at all.
codywayne718   +1y
Thank you! Guess I'll order one of those bad boys. Guess if something gets fried I'll figure it out then lol
codywayne718   +1y
Just now getting around to ordering this thing. I can't tell if this is a 1 wire or 3 wire. Anyone wanna help me out some more? Lol just want this to go as easy as possible.