Powdercoating

I hope so. Im getting a little bit of ougassing still i believe but i believe its because im letting the part get back down to room temp before i clean spray then coat.









-Justin

nice lemme know if u need any advice or product or help....is that all one coat? primer can help with casting marks and multiple coats bake cycle is a little diff....good start though...anything cast will out gas there tricky ....cycle it a few times more before....we cook the shit outta stuff before we even media blast it......sweat all the oil out....depending on the greasyness sometimes they spend a day at temp before we will even touch them...theres outgassing primers too but there expensive and aren't fool proof......shoot me a pm i help u with pricing....product or advice

rip off baha though i offered to do work for him once.......and to think aww forget it......

j/k baha

Thanks jrock. I knew that you did this kind of work for a living and was hoping that you would chime in on opinions. Im sure i will be hitting you up in a pm very soon with some questions.







-Justin