threads
Page 3 of 3
Mazda Engine General \  Need help bad!!!

Need help bad!!!

Mazda Engine General Mazda Engine Mazda Tech
views 2711
replies 22
following 14
 
spacemonkee23   +1y
This happened to me, I went through two slaves and 3 masters before it was back to normal... The first symptom was the clutch would stay on the floor but would act as if I were slowly releasing it (started engaging slowly and rolling forward at a stop light and i almost wrecked, nothing I could do but shut it off, pop the clutch up with my foot start it and limp it home in first), replaced slave and bled it but the pedal was too soft to push, replaced master, clutch engaged super low to the floor. Replaced both again and was ok for about a week and it started again. Replaced master again and all was good. was a nightmare but finally got it working. Bench bled every time, its just hard to get one in good working order.
richard93   +1y
Damn I guess I got lucky when this happened to me about 3 months ago I changed my master cylinder never bench bled or bled the system after I installed it and I haven't had another problem out of it good luck guys
mazdamatic   +1y
I'm confused is the clutch still engaging good just right off the floor? if its engaging with no problem who cares. now if the pedal is sticking to the floor thats a problem. It seems like we have people talking about two different things here.