Project Engine Overhaul update April 5

LOL. i should have clarified

So here's a update,
I started to fab up a set of upper a-arms there just rough right now still need to weld them up, clean them up and send out to powder coating, also cleaned up my spindles and hubs. I sprayed the back of my hubs with rocker guard for more durability. Should be able to get her in a rolling chassis again soon then small block.

So here's an update, Pick up a good used T-5 trans only had one issue the input shaft bearing is shot but other than that good shape. I got the right side tack up and check for clearance just need to cut the inner fender a little more then the tubs.

Good looking front setup you have there Ryan. Cannot tell from the pics (or I am not looking at the correctly), is there a means for Caster / Camber adjustment on the upper control arm?

looking good. did you have your navi's redrilled? got a picture of that?