Project: Paint Runner

It's been a couple weeks I haven't done much I've been car shopping for the wife aka tow pig. But I did get out In the shop today and weld up the notches ://img.tapatalk.com/d/14/06/16/a5u4aje2.


Sent from my iPhone using Tapatalk

Lookin good

Sent from my QMV7A using Tapatalk

We'll finally finished up notching the truck after being in vacation.://img.tapatalk.com/d/14/06/29/va5ypu9a.://img.tapatalk.com/d/14/06/29/y5anuzen.jpg


Sent from my iPhone using Tapatalk

Good score on the new ride. The notches look good too.

Thanks man yeah the wife loves Chevys! Rides like a dream


Sent from my iPhone using Tapatalk

We'll I knew it would happen so here it is. I made my first of I'm sure a few mistakes along the road! When I put my notches in the truck was not level so u know what that means I was freaking out at first rushed and put the bed on make sure it lined up still which in my head I knew it would and it did I have the axle clearance I need so I'm going to call these notches lean back!


Sent from my iPhone using Tapatalk

Still kicking myself in the face dang it!


Sent from my iPhone using Tapatalk

Ok got all my measurements together checked my wheel base should be able to start on the links this weekend.


Sent from my iPhone using Tapatalk

In for updates


Sent from my iPhone using Tapatalk

Ok guys I'm in need of some advice I setup my rear end over the weekend. My pinion angle is setup on -3 on the rear end just want to make sure I'm doing this right before I weld in my links. Here's some pic://img.tapatalk.com/d/14/07/07/ugyjyhat.


Sent from my iPhone using Tapatalk