Rear Brake proportioning valve

Some come with the proportioning valve. If you order it directly from Wilwood I think. I've seen them before, on recent installs. I'm going to Chucks wheel and rbake tomorrow, I'll let you know how it goes.

I got them today. Its 1/8" NPT to 3/16" brake line. Don't go to the parts stores, try a brake specialty shop. They were $2.50 each.

I thought all the Toyota brake fittings were 10 mm x 1.0 mm , so you would need a fitting going from metric to standard thread,3/8'' x 24unf

What I did was use 3/16" line and put a metric end on it. Most of my lines are standard, only the ends where they meet the brakelines and the master cylinder are metric.

See on the 89-95 models they are all metric.. They have 3/16th line with 10mm ends kinds stupid IMO

I guess I didn't word that entirely right. Most of my lines are standard NOW. They were all metric. But with the proportioning valve and disc brake swap, half of the ends are metric and half are standard. So I've been swapping ends on the line as needed. I'm almost done with all the brakelines.

jegs.com ?
jegsonline.com?
fuck it, ill use stock ones